OMG OMG OMG OMG.
A CRAFT POST. A CHRISTMAS CRAFT POST!!!!!
Holy smokes, she’s back! Yup, this craft blogger has some crafts to show you! I mentioned a few posts back that I have ben focusing lately on getting healthy and losing weight — well, I am more than 30 lbs down (Thank goodness! Chubby me was tired of being chubby!) and feel like I have a much better grasp on the balance between eating, exercising and all other fun activities like CRAFTS!
Enter Rudolph the wine cork reindeer!
To make this freakin’ adorable ornament, first start with a cork. I like the corks that aren’t true corks. They have a layer of skin (almost) to them that makes this project easier than if you were to use a true cork.
Drill through the cork — don’t go top to bottom, rather drill through the side of the cork, somewhat near the top. This will be the heigh of your antlers.
Cut a long piece of malleable brown wire and fold it in half. Stick the wire through your drilled hole, sending the folded end through the cork first. I learned the hard way that it is much more difficult to get your wire through your cork if the sharp end leads the way.
Your cork should sit in the middle of your wire.
Next, it’s time to form your antlers. I folded the wire about 1.5 inches from the base and twisted the wire until it touched the cork. Then, with the extra wire I wrapped back up the twisted portion and did this again. I ended up with three-pronged antlers, with the extra wire wrapping down along the base of each. Do this on both sides.
Once the antlers were on, I screwed an eye hook into the top of the cork to make this an ornament.
Time for the eyes and nose!
Here’s where your cork having “skin” is important. I took a nail and pressed it through the skin of the cork as an appropriate eye level for rudolph. It went in at one point and came out another — these entry/exit points are where the wire will enter and exit.
Once you create your hole and feed your wire through, add see beads for eyes. Get them as close to the cork as possible, then wrap wire around the base of each eye to secure them to the cork.
I used this exact same process for the nose. I tried to make the entry and exit points closer together when feeding the nail through the cork since the nose didn’t need no be spaced far apart like the eyes. I used beads and bells on different ornaments, but each one needs to be secured to the cork by wrapping the wire around the base.
The final step is to add a ribbon! Voila! Rudolph the Red-Nosed Wine Cork!
Cork Rudy is hanging on my mini tree in my office. Yes, I’ve started decorating already 🙂